Omron Programmable Terminals NT31 NT31C Setup Manual page 230

System Maintenance
Checking
Communication with a
Printer
220
Check communication with a printer by following the menu operation from the
System Menu shown below.
Ver 3.10
• While data is being sent to the printer, the message Checking Now... is dis-
played.
• When the sending of data to the printer is completed, Finished Normal by Print-
er Interface Check is displayed.
Select Maintenance Mode.
Select I/O Check.
Select I/F Check.
Select Printer.
Confirm that a printer is connected to the
NT31/NT31C, then press Execute: Printer
Interface Check will be printed out at the
printer.
Section 6-11