System Settings Section; Setting The Start-Up Wait Time - Omron Programmable Terminals NT31 NT31C Setup Manual

System Settings
[ ] (next screen)

6-9-2 Setting the Start-up Wait Time

The four memory switch setting screens are shown below.
[ ] (next screen)
[ ] (previous screen)
[ ] (previous screen)
[ ] (next screen)
[ ] (previous screen)
Memory Switch Settings
A list of the memory switch settings is presented below.
• Start-up Wait Time
• Key Press Sound
• Buzzer Sound
• Printer Controller
• Print Method
• Screen Saver Movement
• Screen Saver Start up Time
• Hist. Disp. Method
• Resume Function
• Comm. Auto-return
• Time-out Interval
• Retry Counts
• Comm. A Method
(For the bar code reader, refer to page 188.)
• Comm. B Select
• Comm. B Method
For details on each setting, refer to the pages indicated.
The Start-up Wait Time is the time lapse until the NT31/NT31C switches to the
RUN mode after its power has been switched ON or after it has been reset. Set
this item if it takes some time for the host to start operation. Nothing is displayed
during the Start-up Wait Time.
The setting range is 0 to 10 seconds. The default (factory) setting is 00sec.
[ ] (next screen) [ ] (previous screen)
page 169
page 170
page 171
page 172
page 174
page 175
page 177
page 179
page 181
page 183
page 185
page 186
page 157
page 167
page 157
Section 6-9
169