Riso rz 590 User Manual page 168

Troubleshooting
Problem
The back of the printed card is
peeling, or the leading edge
gets wrinkled.
An error message displays
even though there is no paper
jam.
When printing a multiple page
computer file, the machine
repeats the master-making
process one page at a time.
The computer sent the file, but
it was not received by the
machine.
The key is blinking.
166
Troubleshooting
Possible Cause
The angle of the Stripper Plate is in
appropriate
Is the lifted paper getting ejected at
the second rotation of the Print
Cylinder (Drum)?
Is sunlight directly hitting the
machine?
Is "Print in Units" option selected in
the Printer Driver?
Is the Admin. screen currently
showing on the display?
Received data is waiting for output?
Action
Turn the Stripper Plate Angle Adjustment
Dial to adjust the angle.
Check the printed copy, and if the top
margin is less than / " (5 mm), slightly
3
16
lower Print Position.
The sensor is affected by direct sunlight.
Install shades or curtains, or move the
machine out of direct sunlight.
Delete the current print job. Deselect "Print
in Units", and resend the data to the
machine.
See p.38, step 3.
p.41
Touch and switch to the Basic Screen
from the Admin. screen.
Press the key and proceed to print.