Riso rz 590 User Manual page 148

Troubleshooting
Message
Master Not Set in Place
Insert Lead Edge of Master into
Master
Entrance and Close Master Making
Unit
Master Remains on Print Cylinder
Pull Out Print Cylinder and
Remove Master
Safety SW on Standard Feed Tray
is Activated
Reset paper on Standard Feed Tray
System Error in Master Making Unit
Take Out Master and then
Close Master Making Unit Cover
B00-000:Optional Device Error (in alphabetical order)
Message
Data Transfer Error for Linked
Printer
Check Network and Linked Printer
Then Transfer Data Again
Insert Card in Key/Card Counter
!! Job Separator is OFF !!
Turn On Power Switch of it
Linked Printer in Error
No IP Address Assigned to This
Printer
Contact Your Network Administrator
!! No Linked Printer Detected !!
Check Cable Connection and Power
Supply for Linked Printer
146
When a Message Displays
Possible Cause
The master is improperly
installed or is missing.
An unnecessary master
remains on the Print Cylinder
(Drum).
The safety switch for the Paper
Feed Tray has been activated.
The cutter mechanism for the
master malfunctioned.
Possible Cause
Cannot transmit data to Linked
Printer.
No card in the Key Card
Counter (option).
The Job Separator (option) is
turned OFF.
A Service Call Error has
occurred on the Linked Printer.
IP address for the machine is
not properly set.
Linked Printer may not be
turned ON; cable may not be
properly connected; connection
may be interrupted.
Action
Pull out the Master Making Unit and
reinstall the master.
p.129
Important!:
• If the leading edge of the master is
wrinkled or torn, cut the edge straight
and reinstall.
1)
Pull out the Print Cylinder (Drum) and
remove the master from the cylinder
(drum).
p.135
2)
Return the Print Cylinder (Drum) in
place.
Check underneath the Paper Feed Tray
and on top of the printing paper for any
obstructions. Remove if any exist.
Pull out the Master Making Unit and
remove the master.
p.129
Closing the Master Making Unit Cover will
reset the error. Setup the master again.
Action
Check connections from Linked Printer
and the machine to the hub. If they are
properly connected, check the server and
network communication status and
consult with the network administrator.
Insert Card in the Key Card Counter.
Turn on the Job Separator.
Check the Linked Printer and resolve the
error.
Contact your system administrator and set
the machine IP address correctly.
p.99
Check that the Linked Printer has been
switched on.
Check to make sure all cables are
properly connected. If properly connected,
check for damaged cable.