Riso rz 590 User Manual page 167

Problem
Printed copies are not neatly
aligned in the Paper Receiving
Tray.
Paper is not smoothly fed from
the Paper Feed Tray.
(skipped paper, or multiple-
sheet feeding)
Possible Cause
The positions of the Receiving Tray
Paper Guides and the Paper Stopper
are inappropriate.
The Paper Arrangers are not properly
set.
The print paper is inappropriate.
The position of the Paper Feed
Pressure Adjustment Lever was
inappropriate.
The angle of the Stripper Plate is
inappropriate.
The Paper Feed Adjustment on the
Functions screen is not properly set.
Troubleshooting
Action
Adjust the Receiving Tray Paper Guides
and the Paper Stopper to the size of
paper. For thick paper, slightly widen them
as necessary.
If you have adjusted the horizontal
position on the Paper Feed Tray, shift the
Receiving Tray Paper Guides in the same
direction.
p.31
Set the Paper Arrangers properly.
p.31
Use paper that falls within the
recommended range.
p.12
When using thick or slippery paper, set the
Paper Feed Pressure Adjustment Lever to
"Thick Paper".
p.28
Turn the Stripper Plate Angle Adjustment
dial as follows;
• When the feeding skips
Turn the dial to the left.
• When multiple sheets are fed
Turn the dial to the right.
Important!:
• Before making the adjustment, be sure
to remove all paper from the Paper
Feed Tray and confirm that the tray has
lowered to the bottom.
Adjust the "Paper Feed Adj.". Contact your
dealer (or authorized service
representative) for details on making the
adjustment.
Troubleshooting
165