Riso rz 590 User Manual page 156

Troubleshooting
Message
Enter Print Quantity Over
[nn],
Programed Minimum Value
Invalid Print Cylinder
has been Selected
Change Cylinder, or
Reselect Cylinder Size
!! Multi-Up is Not Available
with This Paper Size !!
Replace with Proper Paper
of Standard Size
No Master on Print Cylinder
Make a New Master
!! Number of Copies
is set to "0"!!
Printing Operation will
Start on this Printer
154
When a Message Displays
Symptom/Action
(Symptom)
You are trying to print fewer copies than
previously specified on "Minimum Print
Quantity".
(Action)
Enter a larger number to print, or change
"Minimum Print Quantity" on the Admin.
screen.
p.101
(Symptom)
You have selected a different Print
Cylinder (Drum) than the one currently
in place, as confirmed in the Confirm
Cylinder (Drum) Type screen when it
was installed.
(Action)
Select the type of Print Cylinder (Drum)
currently installed.
Alternatively, you can change the Print
Cylinder (Drum).
p.135
(Symptom)
Multi-up functions cannot be used when
custom-sized paper is in the Paper Feed
Tray.
(Action)
Load standard size paper in the Paper
Feed Tray.
(Symptom)
You are attempting to print, but there is
no master on the Print Cylinder (Drum).
(Action)
Set the original and create a master.
(Symptom)
Number of print copies is set to "0", yet
"Link-Free Volume" is set to ON when
Linked Printer is connected.
(Action)
Enter print quantity.
p.102
How to Clear a Pop-Up Message
Touch [Close], and specify the number
of copies higher than the number
displayed on the message.
• When changing a setting;
In the Confirm Cylinder (Drum) Type
screen, select the type of Print
Cylinder (Drum) currently installed
and touch [OK].
• When installing a different Print
Cylinder (Drum);
Pull out the Print Cylinder (Drum) and
replace with the correct one.
When the Print Cylinder (Drum) is re-
installed, the Warning Message will
clear.
Touch [Close].
(Alternatively, press the
key to clear.)
Touch [Close].
Important!:
• Do not leave the Print Cylinder (Drum)
without a master. This dries out the
cylinder (drum) and causes damage.
You must either create a master or
perform a "Confidential" operation to
wrap a master around the Print
Cylinder (Drum).
• When printing from the machine;
Touch [Continue].
(Alternatively, press the
print.)
• When stopping the print job;
Touch [Cancel].
(Alternatively, press the
the key to clear.)
key or the
key to
key or