Mapping Devices Automatically; Mapping Devices Manually; Multiple Node Addressing (Fb2400 Only) - ATTO Technology FibreBridge 2370E Installation And Operation Manual

Mapping devices automatically

1 If you are not already in
the ExpressNAV
interface, type the IP
address of your
FibreBridge in a
standard browser as
Using
found in
ExpressNAV
on page
25, click Enter Here,
type in your user name
and password, and click
OK .
1 The Status page
appears.
2 From the ExpressNAV
main menu, click on the
Mapping menu item on
the left side of the
screen.
3 The Mapping page
appears. Wait for the
automatic scan for devices to complete.
4 Click AutoMap

Multiple Node addressing (FB2400 only)

The FibreBridge has a unique Port name for each
Fibre Channel port. By default, each Fibre
Channel port also has a separate unique Node
name: the host computer perceives the
FibreBridge as two separate entities, allowing
mapping of a different set of logical units to each
FC port.
You may use a combination of the Command
Line Interface and ExpressNAV to change the
default setting to create a single Node name for
the FibreBridge and map devices to that node.
1 Connect to the FibreBridge using the
Command Line Interface as described in
Interface options
on page 25.
All the commands necessary to enable
mapping and the command
saveconfiguration norestart are performed.

Mapping devices manually.

1 If you are not already in the ExpressNAV
interface, type the IP address of your
FibreBridge in a standard browser as found in
Using ExpressNAV
Here, type in your user name and password,
and click OK .
1 The Status page appears.
2 From the ExpressNAV main menu, click on the
Mapping menu item on the left side of the
screen.
3 The Mapping page appears. Wait for the
automatic scan for devices to complete.
4 Select the devices from the box on the right
hand side of the screen and drag to the
appropriate LUN on the left.
5 Click Submi t. All the commands necessary to
enable mapping and the command
saveconfiguration norestart are performed
At the Ready prompt, type
2
set FCMultiNode disabled
Note
Changing the state of the FCMultiNode
command causes all maps to be deleted.
3 Press Enter .
4 Type saveconfiguration restart.
5 Press Enter.
6 Follow the directions in
automatically Mapping devices manually.
or
above.
on page 25, click Enter
Mapping devices
18