Panasonic KX-TDA30 Features Manual page 175

– When a trunk call is transferred to another trunk
– When a trunk call to an incoming call distribution group is answered by an outside destination
member
Before the call is made, the PBX confirms that a DISA port is available. If no DISA ports are available,
the call is not routed to a trunk. For transferred calls or calls to an ICD Group, if the DISA port has
become unavailable when the trunk-to-trunk conversation is actually established, the call is established
without DISA.
When using this feature, the Trunk-to-Trunk Call Limitation timer should be enabled. In addition,
prolonging the call through DTMF signalling is not available.
• DISA Call Transfer from Outside Destination
An outside party such as a cellular phone can transfer a trunk call to an extension at the PBX by
pressing "#" + extension number, if DISA is connected by the Automatic DISA Activation feature. This
feature can be enabled or disabled through system programming.
– The KX-TDA6920, KX-TDA0920 or KX-TDA3920 SD Memory Card for Software Upgrade to
Enhanced Version is required to use this feature.
– DISA security mode should be set to No Security or Trunk Security.
– If the called extension does not answer, is busy, or is in DND mode, the DISA Intercept feature
operates.
– The party on hold can use the Call Retry feature.
– End of Call Detection does not operate after dialling "#".
– Calls can only be transferred to extensions within the PBX.
– Transfer Recall, Call Splitting and Call Transfer with Announcement are not available.
• DISA Reorder Tone Duration
It is possible to set the DISA Reorder Tone Duration time. This specifies the length of time that a reorder
tone will be sent to the caller. When the timer expires, the call will be disconnected. Call Retry is
possible during the DISA Reorder Tone Duration time.
• Call Deny
Extensions can deny DISA calls on a COS basis.
• Verification Code PIN Lock/Extension PIN Lock
If the wrong PIN is entered three times, the line will be disconnected. If the wrong PIN is entered a
preprogrammed number of times successively, that extension or verification code will become locked,
and even entering the correct PIN will not unlock it. Only an extension assigned as the manager can
unlock it. In this case, the PIN will be unlocked and cleared.
• DISA Automatic Walking COS
– The KX-TDA6920, KX-TDA0920 or KX-TDA3920 SD Memory Card for Software Upgrade to
Enhanced Version is required to use this feature.
• Each outgoing message (OGM) can be assigned a name through system programming for
programming reference.
→ [731] Outgoing Message (OGM) Name
Installation Manual References
KX-TDA30
2.5.4 MSG2 Card
KX-TDA100/KX-TDA200
2.6.1 OPB3 Card (KX-TDA0190)
2.6.6 MSG4 Card (KX-TDA0191)
KX-TDA600
2.8.1 OPB3 Card (KX-TDA0190)
1.16 Optional Device Features
Feature Guide 175