Panasonic KX-TDA30 Features Manual page 147

• SLT Hold Mode
It is possible to choose how to hold a line and transfer a call with an SLT in the following methods
through system programming:
Mode 1
Mode 2
(Default)
Mode 3
Mode 4
If the following occurs frequently with an SLT, choose "Mode 2", "Mode 3", or "Mode 4":
a)
When an SLT user receives a call, reorder tone is heard or nobody answers the call.
b)
When an SLT user goes off-hook, reorder tone is heard instead of a dial tone.
If a call is not terminated after going on-hook, the above cases occur. To avoid these problems, choose
"Mode 2", "Mode 3", or "Mode 4". Every call will be terminated unless the Hold feature number is
entered after flashing the hookswitch in Mode 2, Mode 3, and Mode 4.
• Hold Alarm tone pattern has a default. (→ 3.3.1 Tones/Ring Tones).
PT Programming Manual References
[200] Hold Recall Time
User Manual References
1.4.2 Holding a Call
Hold
Flashing the hookswitch
+
Going on-hook
Flashing the hookswitch
+
Hold Feature No.
+
Going on-hook
Flashing the hookswitch
+
Hold Feature No.
+
Going on-hook
Flashing the hookswitch
+
Hold Feature No.
+
Going on-hook
Transfer to Trunk
Flashing the hookswitch
+
Trunk Access No.
Flashing the hookswitch
+
Trunk Access No.
Flashing the hookswitch
+
Hold Feature No.
+
Trunk Access No.
Flashing the hookswitch
+
Hold Feature No.
+
Trunk Access No.
1.12 Holding Features
Transfer to Extension
Flashing the hookswitch
+
Extension No.
Flashing the hookswitch
+
Extension No.
Flashing the hookswitch
+
Extension No.
Flashing the hookswitch
+
Hold Feature No.
+
Extension No.
Feature Guide 147