Panasonic KX-TDA30 Features Manual page 171

• Intercom call
• TIE line call
• Trunk call
• Call Forwarding (FWD)/Do Not Disturb (DND) setting (→ 1.3.1 Call Forwarding (FWD)/Do Not
Disturb (DND))
• Incoming Call Distribution Group Log-in/Log-out (→ 1.2.2.7 Log-in/Log-out)
• Absent Message setting (→ 1.18.2 Absent Message)
• Extension Dial Lock (→ 1.8.3 Extension Dial Lock)
• Time Service Switching Mode (→ 2.2.4 Time Service)
DISA Automatic Walking COS
Registered outside destinations such as cellular phones can be automatically recognised as PBX
extensions when calling through DISA. When the Caller ID of a received trunk call matches an entry in the
System Speed Dialling Table, the calling telephone is given Walking COS authorisation as assigned to the
corresponding CLI destination extension. Therefore, the "CLI destination" setting in the System Speed
Dialling Table is used here to specify the target extension that the calling telephone will be recognised as
for Walking COS.
[Programming Example of DIL Table]
Trunk No.
Day
01 Disable
:
"CLI" must be set to Disable, to allow incoming calls to be received by DISA.
[Programming Example of System Speed Dialling Table]
Location
000
001
:
In this example, calls received on trunk 01 are routed to the DISA OGM with floating extension number 501.
If the number of the received call (after modification according to the Caller ID table) is "12341115678", the
call originator is recognised as extension 200, and the Walking COS feature is automatically activated.
System programming is required to enable this feature.
SMDR
The call information for DISA is recorded as the one of the DISA floating extension numbers. (→ 1.25.1
Station Message Detail Recording (SMDR))
CLI
Lunch
Disable
: :
Telephone No.
912341115678
:
:
Destination
... Day Lunch
501
...
(DISA) (DISA)
: :
System Speed Dialling
Name
J. Smith
:
:
1.16 Optional Device Features
...
501
...
: :
CLI Destination
200
:
:
Feature Guide 171