Port Configuration - NetComm NF13ACV User Manual

OPTION
VPN-PPTP server
Server virtual IP
IP pool start address
IP pool end address
Authentication protocol
MPPE encryption mode
NAT
Encryption length

Port configuration

The port configuration page provides the ability to manually configure the speed of each of the LAN and WAN ports to 100Mbps full
or half duplex or 10Mbps full or half duplex. When Auto is selected, the NF13ACV selects the highest possible speed that both
nodes are capable of. Selecting Auto therefore prioritizes Gigabit Duplex connectivity.
To access the Port configuration page, click on the Networking menu at the top of the screen then click on the Port configuration
menu item.
Use the drop down lists to select the mode you want the chosen port to operate at. In most cases, it is best to leave these settings
as "Auto" but there may be situations where you want to limit or force a port to behave in a certain manner.
When you have finished making changes, click the Save button to ensure that your changes take effect.
NetComm Wireless AC1200 WiFi Gigabit Router with Voice
42
Enables/disables the PPTP server.
Specifies the PPTP server network IP address.
Specifies the start of the IP pool address range to assign to clients.
Specifies the end of the IP pool address range to assign to clients.
Select the Authentication protocols to use. Options are PAP, CHAP, MS_CHAP and MS_CHAPv2.
Enables/disables the Microsoft Point-to-Point Encryption protocol.
Enables/disables network address translation on the PPTP server network.
Selects the level of encryption applied to the tunnel.
Table 14 - PPTP server
DEFINITION
www.netcommwireless.com
UM-00013 v1.0