Advertisement
Configuration Guide
Netcomm NF12
Netcomm NF12
IMPORTANT MESSAGE
Your router has been pre-configured, you do not need to
follow each step of the set-up guide but should retain this
document in case you need to manually configure your
equipment.
To configure your PC/Laptop with your wireless password including
changing your wireless password, please proceed to step 4.
Contents
1. Physical Connection
2. Network Configuration
3. Configuring Internet
4. Configuring WI-FI
5. Change of Password
1. PHYSICAL CONNECTION
Please refer to the Quick Reference Guide or Welcome Pack that came with
your router.
PLEASE NOTE: Have your router powered on and connected directly to your
PC via Ethernet Cable before you begin, as these instructions are based on
wired Ethernet connection
2. NETWORK CONFIGURATION
PPPoE connection does not require you to have an IP address or DNS
settings manually encoded on your network card.
PPPoE connection uses authentication to establish the Internet
connection and its after doing this that your router is assigned an
IP and DNS settings from TPG.
To begin, your PC needs to receive a private IP address from the
router. Most NBN routers have DHCP enabled by default that
will take care of this.
1
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for NetComm NF12
Summary of Contents for NetComm NF12
- Page 1 Configuration Guide Netcomm NF12 Netcomm NF12 IMPORTANT MESSAGE Your router has been pre-configured, you do not need to follow each step of the set-up guide but should retain this document in case you need to manually configure your equipment. To configure your PC/Laptop with your wireless password including changing your wireless password, please proceed to step 4.
- Page 2 Configuration Guide Netcomm NF12 To ensure your Network Card is ready for this, please follow the following steps: A. Click on Start -> Control Panel -> Network and Internet -> Network and Sharing Center -> Change adapter settings B. Right click on Local Area Connection and select Properties C.
- Page 3 Configuration Guide Netcomm NF12 3. CONFIGURING ROUTER A. Open your browser and in the address bar type http://192.168.1.1 and press Enter B. Enter admin for both the username and password and click OK. If you have changed the login credentials, please enter the current username and password for your router interface.
- Page 4 Configuration Guide Netcomm NF12 4. CONFIGURING WI-FI To use Wi-Fi, ensure that you have already setup your wireless adapter on your PC/laptop. A. Click Start > Control Panel > Network and Internet > Network and Sharing Center > Change adapter settings B.
- Page 5 Configuration Guide Netcomm NF12 5. CHANGE OF PASSWORD For security purposes we highly recommend that you change your password if you are using your default or if you believe your password security has been compromised. To change your password, first please visit www.tpg.com.au/password...
Need help?
Do you have a question about the NF12 and is the answer not in the manual?
Questions and answers