NetComm NF13ACV User Manual page 46

SNMP
SNMP (Simple Network Management Protocol) is a protocol designed to give a user the capability to remotely manage a computer
network by polling and setting terminal values and monitoring network events.
OPTION
You must check Local, Remote or both to enable SNMP function. If Local is checked, this device will only respond to requests
Enable SNMP
from LAN connected hosts. If Remote is checked, this device will respond to requests from the WAN connection.
Get Community Sets the community string your device will respond to for Read-Only access.
Set Community Sets the community string your device will respond to for Read/Write access.
Input your SNMP Management host IP here. You will need to configure the address where the device should send SNMP Trap
IP 1, IP 2, IP 3, IP 4
messages to.
SNMP Version Please select proper SNMP Version that your SNMP Management software supports.
WAN Access IP Address You can limit remote access to a specific IP address by entering it here.
Note: If "Remote" access is enabled, the default setting of 0.0.0.0 means any IP can obtain SNMP protocol Information.
Click the Save button to store your setting or the Undo button to discard your changes.
NetComm Wireless AC1200 WiFi Gigabit Router with Voice
46
Figure 42 - SNMP
DEFINITION
www.netcommwireless.com
UM-00013 v1.0