NetComm NF13ACV User Manual page 19

ITEM
Activate
Type
Dynamic IP address
Host Name
ISP registered MAC address
Static IP address
WAN IP address
WAN subnet mask
WAN Gateway
Primary DNS
Secondary DNS
PPP over Ethernet
IPv6 Dualstack
Username
Password
Primary DNS
Secondary DNS
Service Name
Assigned IP address
MTU
NAT
www.netcommwireless.com
UM-00013 v1.0
Figure 7 - Ethernet WAN settings – PPP over Ethernet
Turns on or off the Ethernet WAN connection.
Sets the type of Ethernet WAN connection.
Set the DHCP option 12 – Hostname, specifies the name of the client that will be sent to the DHCP server.
Use this field to specify the MAC address that is presented to the ISP. This is useful when the ISP has locked the connection
to a specific MAC address. Pressing the Clone button will automatically enter the MAC address of your computer's network
card.
The WAN IP address of your Ethernet WAN connection.
The WAN IP subnet mask of your Ethernet WAN connection.
The Gateway address of your Ethernet WAN connection.
The primary Domain Name Server, usually provided by your WAN service carrier.
The secondary Domain Name Server, usually provided by your WAN service carrier.
When set to the ON position, the router also passes the IPv6 protocol over the PPPoE connection simultaneously with IPv4.
The username of the PPPoE connection.
The password of the PPPoE connection.
The primary Domain Name Server, usually provided by your WAN service carrier.
The secondary Domain Name Server, usually provided by your WAN service carrier.
The Service Name is used to identify the PPPoE service. This may be required by your ISP in certain circumstances.
The IP address assigned to your connection by the carrier.
The Maximum Transmission Unit. Leave this at 0 to have it automatically set according to the network.
This toggle switch turns on or off the Network Address Translation function.
DEFINITION
NetComm Wireless AC1200 WiFi Gigabit Router with Voice
19