NetComm NF13ACV User Manual page 34

RIP
RIP (Routing Information Protocol) is used for advertising routes to other routers. Thus all the routes in the router's routing table will
be advertised to other nearby routers. For example, the route for the router's Ethernet subnet could be advertised to a router on the
PPP interface side so that a router on this network will know how to route to a device on the router's Ethernet subnet. Static routes
must be added manually according to your requirements. See
To access the RIP configuration page, click on the Networking menu at the top of the screen, click on the Routing failover menu on
the left, then click on the RIP menu item.
Note: Some routers will ignore RIP.
To enable Routing Information Protocol (RIP)
Click the RIP toggle key to switch it to the ON position.
Using the Version drop down list, select the version of RIP that you would like to use.
Click the Save button to confirm your settings.
NetComm Wireless AC1200 WiFi Gigabit Router with Voice
34
Adding Static Routes.
Figure 28 - RIP configuration
www.netcommwireless.com
UM-00013 v1.0