Table of Contents
Advertisement
6. 3G Settings
6.1 Setup
This page allows you to select your 3G service settings according to predefined or custom profiles. Setup instructions are provided in the
following sections for your assistance.
Your 3G Service Provider will provide the information required to complete the first time setup instructions below. This includes profile,
username and password. Only complete those steps for which you have information and skip the others.
1. If your SIM card is not inserted into the Router, then do so now.
2. Select the appropriate 3G Settings Profile. You can select either mobily Prepaid or mobily Postpaid. Alternatively, enter a custom
connection profile by clicking on the "Modify Profiles" link, then click the "Add" button and enter the details supplied by your
3G provider.
3. Select to turn IP compression and Data compression to be On or Off. If you are unsure or have no preference, leave it as the
default value.
4. Enter the MTU rate. If you are unsure or have no preference, leave it as the default value
5. Click the Save button to save the new settings.
6. Press the Connect button to connect to Internet. The Device Info for the 3G network status box in the WUI Basic screen should
indicate an active connection.
6.2 Signal Selection
By default, a stable signal is obtained from the antennas built into the Connect Router. To use an external 3G antenna, please connect it to the
Antenna Connector next to the Power Input on the back of the router. The router will automatically use the external antenna connector when
an external antenna is connected to it.
6.3 PIN Configuration
This screen allows for changes to the 3G SIM card PIN code protection settings.
NOTE: If you have entered the incorrect PIN 3 times, your SIM card will be locked for your security. Please call Mobily for assistance.
HSPA+ 42Mbps WiFi Router User Guide
16
YML42
www.netcomm.com.au
Advertisement
Table of Contents
