Table of Contents
Advertisement
Figure 12 Network Status screen
The following information can be viewed:
•
Ethernet Address – MAC address of the WLAN IP Telephony Manager 2245 (hexadecimal).
•
System Uptime – the number of days, hours, and minutes since the WLAN IP Telephony
Manager 2245 was last reset.
•
Net – the type of connection to the Ethernet switch currently utilized.
Displayed as 10 (10BaseT) or 100 (100BaseT)/half-duplex, full-duplex, or auto-negotiate.
•
maximum calls – number of calls that can be supported by the WLAN IP Telephony Manager
2245 (depends on network speed).
•
RX – Ethernet statistics about the received signal during System Uptime.
— bytes – bytes received
— packets – packets received
— errors – sum of all receive errors (long packet, short packet, CRC, overrun, alignment)
— drop – packets dropped due to insufficient memory
— fifo – overrun occurred during reception
— alignment – non-octet-aligned packets (number of bits not divisible by 8)
— multicast – packets received with a broadcast or multicast destination address
•
TX – Ethernet statistics about the transmitted signal during System Uptime.
— bytes – bytes transmitted
— packets – packets transmitted
— errors – sum of all transmit errors (heartbeat, late collision, repeated collision, underrun,
carrier)
— drop – packets dropped due to insufficient memory
— fifo – underrun occurred during transmission
73
Troubleshooting
Advertisement
Table of Contents
