Freeing The Serial Port For Administrative Purposes - Nortel MOG6xx Installation And Configuration Manual

Freeing the serial port for administrative purposes

If the serial port is being used as the primary communication link with the Application Server, it is
necessary to enter the OAI command to free the serial port so that it can be used for administrative
purposes, such as changing the IP address of the WLAN Application Gateway 2246.
After configuring the WLAN Application Gateway 2246, perform the following steps to again use
the serial port as the communication link with the Application Server.
Disconnect the terminal or PC from the serial port on the WLAN Application Gateway 2246.
1
Reconnect the communication cable between the WLAN Application Gateway 2246 and the
2
Application Server.
Reset the system.
3
Normal communication between the Application Server and WLAN Application Gateway 2246
commences.
Appendix B: WLAN Application Gateway 2246
107