Configuration; Connecting To The Wlan Application Gateway 2246 - Nortel MOG6xx Installation And Configuration Manual

86

Configuration

This section explains how to configure the WLAN Application Gateway 2246.
For an overview of the WLAN Application Gateway 2246, refer to
2246" on page
For information on installing the WLAN IP Telephony Manager 2245, refer to
page 80.
Tasks:
• Connect to the WLAN IP Telephony Manager 2245
Gateway 2246" on page
• Configure the WLAN IP Telephony Manager 2245
Gateway 2246" on page
• Change the password
• Save the configuration
• Check system status

Connecting to the WLAN Application Gateway 2246

The initial connection to the WLAN Application Gateway 2246 must be made through a serial
connection to establish the IP address of the WLAN Application Gateway 2246 and the network
parameters.
Further configuration and administration can be performed at a later time through a Telnet
connection.
The Telnet method of connection is also used for routine maintenance of the WLAN Application
Gateway 2246.
Tips: Nortel Networks recommends that you complete the initial network configuration
through the serial connection.
You should also change the default password immediately for security reasons (see
"Connecting to the WLAN Application Gateway 2246" on page
Appendix B: WLAN Application Gateway 2246
79.
86)
88)
("Connecting to the WLAN Application Gateway 2246" on page
("Connecting to the WLAN Application Gateway 2246" on page
("Connecting to the WLAN Application Gateway 2246" on page
"WLAN Application Gateway
("Connecting to the WLAN Application
("Configuring the WLAN Application
86).
"Installation" on
86)
86)
86)