Wlan Ip Telephony Manager 2245 Configuration; Connecting To The Wlan Ip Telephony Manager 2245; Connecting Through A Serial Port - Nortel MOG6xx Installation And Configuration Manual

WLAN IP Telephony Manager 2245 configuration

This section explains how to configure the WLAN IP Telephony Manager 2245 (SVP II Server).
For an overview of the WLAN IP Telephony Manager 2245, refer to
Manager 2245" on page
For information on installing the WLAN IP Telephony Manager 2245, refer to
Telephony Manager 2245 installation" on page
Tasks:
• Connect to the WLAN IP Telephony Manager 2245
Manager 2245" on page
• Configure the WLAN IP Telephony Manager 2245
Manager 2245" on page
• Change the password
• Save the configuration
• Check system status

Connecting to the WLAN IP Telephony Manager 2245

The initial connection to the WLAN IP Telephony Manager 2245 must be made through a serial
connection to establish the IP address of the WLAN IP Telephony Manager 2245 and the
maximum number of active calls per access point.
Further configuration and administration can be performed at a later time through a Telnet
connection.
The Telnet method of connection is also used for routine maintenance of the WLAN IP Telephony
Manager 2245.
Security Note: Nortel Networks recommends that you change the default password
!
immediately for security reasons (see

Connecting through a serial port

Connect the WLAN IP Telephony Manager 2245 to the serial port of a terminal or PC using a
1
DB-9 female, null-modem cable.
Run a terminal emulation program (such as HyperTerminal™), or use a VT-100 terminal with
2
the following configuration:
33.
45)
47)
("Changing the password" on page
("Saving the configuration" on page
("Checking the system status" on page
41.
("Connecting to the WLAN IP Telephony
("Configuring the WLAN IP Telephony
52)
53)
54)
"Changing the password" on page
WLAN IP Telephony Manager 2245 configuration
"WLAN IP Telephony
"WLAN IP
52).
45