Sharp MX-3050N User Manual page 549

SCANNER/INTERNET FAX►TRANSMITTING AN IMAGE
Tap the [B/W Start] or [Colour Start] key to start scanning of the original.
5
• If the original was inserted in the document feeder tray, a beep will sound when scanning is completed and
transmission will take place.
• If the original is placed on the document glass, the [Read-End] key appears in the touch panel. If the original is only
one page, go to step 7. To scan more pages, go to step 6.
• When you use the automatic document feeder to scan an original, you can tap the [Preview] key to check a preview of
the image before sending an image. For more information, see
(page 5-62)".
• If the file format is set to [PDF/Encry.], [PDF/Encry./Bk Letter Emphasis], [PDF/Encry./Compact], or
[PDF/Encry./Compact/U-Fine], you will be prompted to enter the password when you tap the [B/W Start] or [Colour
Start] key.
Tap the password entry box to open the keyboard screen, enter a password using a maximum of 32 characters, and
tap the [OK] and [Send] key in sequence. The recipient must use the password entered here to open the Encrypt PDF
file.
To cancel Encrypt PDF, tap the [Cancel] key. The format settings screen will appear to let you change the file type.
Select a new file type and tap the [B/W Start] or [Colour Start] key to begin transmission.
If the original was placed on the document glass, replace it with the next
6
original and tap the [B/W Start] or [Colour Start] key.
Repeat until all originals have been scanned.
Tap the [Read-End] key.
7
A beep will sound to indicate that the operation is completed.
• If no action is taken for one minute after the confirmation screen is displayed, scanning automatically ends and the
transmission is reserved.
• Tap the [Change Setting] key to change the exposure, resolution, scan size, and send size for each original page
scanned. However, when "Card Shot" is selected in Others, change only the exposure when scanning an
even-numbered original page.
To change the time until transmission takes place automatically:
Select "Settings (administrator)" - [System Settings] → [Image Send Settings] → [Common Settings]
→ [Condition Settings] → [Job Auto Start Time During Scanning].
"CHECKING THE IMAGE TO BE TRANSMITTED
5-27