Account/Call Settings - Grandstream Networks GXV3275 Administration Manual

Jitter Buffer Maximum (ms)
RTCP Destination

Account/Call Settings

Start Video Automatically
Video Layout
Remote Video Request
Disable Presentation
Dial Plan Prefix
Disable DialPlan
Dial Plan
Defines the amount of delay to eliminate jitter caused by transmission congestion. The
valid range is from 0 to 1000.The default settings is 50.
Configures a remote server URI where the RTCP messages will be sent to during an
active call.
Permits the phone system to enable the video feature automatically when it makes an
outbound call. If set to "Yes", the video codec attributes will be included in the SIP
INVITE message. Or the attributes will not be included. The default setting is "Yes".
Sets the phone to enable the full-screen mode or just display the remote video in full
screen mode while answering a video call. The default setting is "No".
Configures the preference to handle video request from the remote party during an
audio call. It can be selected from the dropdown list.

"Prompt": A message will be prompted if a video request is received. Users can
select "Yes" to establish video or "No" to reject the request.

"Accept": Video request will be accepted automatically and video will be
established.

"Deny": Video request will be rejected automatically.
The default setting is "prompt".
Configures whether to receive presentation information during conference with
GVC3200. If set to "Yes", the device will disable receiving presentation during
conference. The default setting is "Yes".
Configures the digits prepended to the dialed number.
Enables/disables the Dialplan mechanism for different cases. If the specific case is
checked, the Dialplan mechanism will be disabled.
 Dial Page: It controls the pattern of dialing numbers from the keypad, phone app
and account widget.
 Contact: It controls the pattern of dialing numbers from local, LDAP and
Broadsoft contacts.
 Incoming call history: It controls the pattern of dialing numbers from inbound
call logs.
 Outgoing Call History: It controls the pattern of dialing numbers from outbound
call logs.
 MPK&Click2Dial: It controls the pattern of dialing numbers from MPK app and
the link on the webpage.
The default setting is unchecking all the cases.
Configures the dial plan to establish the expected number and pattern of digits for a
telephone number. This parameter configures the allowed dial-plan for the phone.
Note: Starting from firmware 1.0.3.92, dial plan logic has been improved allowing the
phone to dial out directly when there is only one rule perfectly matched.
GXV3275 Administration Guide
P a g e | 52