Table of Contents
Advertisement
SAFETY SCREEN INSTALLATION -
SAFETY SCREEN INSTALLATION -
1. Hook the safety screen frame over the glass door frame.
2. Gently lower screen on to glass door frame–two (2) magnets located on inside lower part of the screen frame will secure
the screen to the glass door frame.
3. To remove–reverse steps.
OPTIONAL FLUSH LOUVERS INSTALLATION -
919-558a
USED WITH SAFETY SCREEN # 439-929
1. Install two (2) top louver brackets in locations shown below with one
screw each side.
SAFETY SCREEN INSTALLATION -
1. Hook the safety screen frame over the glass door frame.
2. Gently lower screen on to glass door frame–two (2) magnets located on inside lower part of the screen frame will secure
the screen to the glass door frame.
3. To remove–reverse steps.
2. Install the heat deflector with three (3) screws - the screws are located
on under the top of the unit. Loosen the screws–slide deflector on and
tighten screws.
919-558a
MUST BE USED WITH OPTIONAL LOUVERS
MUST BE USED WITH OPTIONAL LOUVERS
3. Install top louver by hooking louver on to brackets installed in Step 1.
4. Install bottom louver assembly by opening bottom louver enough to
MUST BE USED WITH OPTIONAL LOUVERS
Regency® P33E-10 Zero Clearance Direct Vent Gas Fireplace
installation
Magnet locations
allow access to attach bottom louver brackets to unit with one screw
on each side in locations shown below.
Magnet locations
|
41
07.21.15
07.21.15
|
41
Advertisement
Table of Contents
