Unit Assembly Prior To Installation; Venting Introduction - Regency PANORAMA P33E Owners & Installation Manual

Hide thumbs Also See for PANORAMA P33E:

Manual (80 pages)

Table Of Contents

Table of Contents

installation

UNIT ASSEMBLY PRIOR TO INSTALLATION

The Top Facing Support, the Side Nailing Strips and

the 2 Top Standoffs must be correctly positioned and

attached to the top before the unit is put into position.

Top Standoff Assembly

The top standoffs are shipped in a flat position and

must be pulled up and bent into the correct shape.

1) Remove the standoffs from on top of the firebox

by undoing the screws.

2) Take each standoff and bend into the correct

shape. Bend up at the bend lines until the screw

holes in the standoff and the pre-punched screw

holes on the firebox top line-up.

3) Attach the standoffs securely to the top with 4

screws per standoff.

Note: Secure the standoffs to the holes closest

to the edge of the firebox top.

VENTING INTRODUCTION

The P33-10 uses the "balanced flue" technology Co-Axial system. The inner liner vents products of combustion to the outside while the outer liner draws

outside combustion air into the combustion chamber thereby eliminating the need to use heated room air for combustion and losing warm room air up the

chimney.

There are 5 vent systems approved for use with the P33-10: the Regency

Vent, Selkirk Direct-Temp, Amerivent Direct Vent and Security Secure Vent Systems for Horizontal and Vertical Terminations (see following "Venting" Sections

for more details).

Note: These flue pipes must not be connected to any other appliance.

The gas appliance and vent system must be vented directly to the outside of the building, and never be attached to a chimney serving a separate solid fuel

or gas burning appliance. Each direct vent gas appliance must use it's own separate vent system. Common vent systems are prohibited. (See "Rigid Pipe

Venting System" for more details and exceptions).

NOTE: Ensure compliance with the outside vent terminal location before cutting hole as both dimensions must be met.

16 |

Regency® P33E-10 Zero Clearance Direct Vent Gas Fireplace

Top Facing Support &

Side Nailing Strips

Determine the total thickness of facing material

(e.g. drywall plus ceramic tiles) to allow the finished

surface to be flush with the front of the unit. Total

facing thickness can vary from 1/2" (13mm) to

1-1/4" (32mm) thick.