Table of Contents
Advertisement
installation
|
38
OPTIONAL VIGNETTE FINISHING TRIM INSTALL
*If fi nishing the unit Flush with Vignette Finishing Trim - remove top nailing strip from unit if installed–use nailing strip supplied with top trim
piece. Side nailing strips are bent around side trim piece in fl ush fi nish application.
NOTE:
Remove the safety screen, Vignette Faceplate (P33 units
only: remove 2 screws securing lower legs of Faceplate) and
glass door prior to installing the Finishing Trim.
1.
Install the Finishing Trim sides as shown in the diagram, line up
the holes in the side trim with the holes in the fi rebox side.
2.
Secure with one screw per side (on top, the bottom screw is
installed after the Vignette faceplate bracket is in place P33/P33E
only).
3.
Loosen the 3 screws in the top inside edge of the fi rebox.
4.
Slide the Finishing Trim Top over the Side Trim pieces and fi t the
bottom bracket slots over the screws. Tighten the 3 screws to
secure.
5.
Hook Vignette Faceplate brackets into place.
6.
Line up the screw holes on the fi nishing trim and Vignette Face-
plate bracket with the unit–fasten with one screw on each side–
P33 only.
919-566
38 |
Regency® P33E-10 Zero Clearance Direct Vent Gas Fireplace
VIGNETTE FINISHING TRIM
7.
8.
1
Install the lower fi nishing trim (if required)–secure with four
screws.
Hook Vignette Faceplate brackets into place (see specifi c instruc-
tions in unit manual).
Completed install
05.04.15
Advertisement
Table of Contents
