Table of Contents
Advertisement
installation
|
40
OPTIONAL FINISHING TRIM
NOTE:
Remove the safety screen, Vignette Faceplate (P33 units only:
remove 2 screws securing lower legs of Faceplate) and glass door
prior to installing the Finishing Trim.
1)
Install the Finishing Trim sides as shown in the diagram, line up the
holes in the side trim with the holes in the firebox side.
2)
Secure with one screw per side (on top, the bottom screw is installed
after the Vignette faceplate bracket is in place P33/P33E only).
3)
Loosen the 3 screws in the top inside edge of the firebox.
4)
Slide the Finishing Trim Top over the Side Trim pieces and fit the bottom
bracket slots over the screws. Tighten the 3 screws to secure.
5)
Hook Vignette Faceplate brackets into place.
6)
Line up the screw holes on the finishing trim and Vignette Faceplate
bracket with the unit–fasten with one screw on each side.
7)
Reinstall the glass door and safety screen.
40 |
Regency® P33E-10 Zero Clearance Direct Vent Gas Fireplace
919-475
OPTIONAL FINISHING TRIM
1
Finishing
Trim Top
Finishing
Trim Side
10.29.14
Advertisement
Table of Contents
