Optional Vignette Inlay Installation - Regency PANORAMA P33E Owners & Installation Manual

OPTIONAL VIGNETTE INLAY INSTALLATION

NOTE: Inlay not exactly as shown below.
1. Remove Inner Vignette Frame from unit if already installed.
2. Line up the inlay top bracket in the space between the safety
screen frame and Vignette Frame. Slide the Inlay bracket up until it
rests on the inside edge of the Vignette Frame.
Inlay top
bracket
Studs at back of
3. Position the Inlay so it is exactly centered from side to side and top
to bottom within the Inner Vignette Frame.
4. With the top of the Inlay in correct position–push the studs at the
bottom of the Inlay through the actual screen.
NOTE: Ensure Inlay is in correct position before pushing studs through
the safety screen.
Line up Inlay–Push studs on
919-559
Vignette Inlay
Inlay through screen
OPTIONAL VIGNETTE INLAY
5. Secure the Inlay in position with supplied brackets, washers, and
nuts as shown.
Bracket
(supplied)
Completed Install
Regency® P33E-10 Zero Clearance Direct Vent Gas Fireplace
installation
|
Back of Inner
Vignette Frame
Stud
Nut + washer
(supplied)
05.21.15
39
| 39