Manually Configure An Ipv6 Internet Connection - NETGEAR FVS318N Reference Manual

3. In the DHCPv6 section of the screen, select one of the following radio buttons:
• Stateless Address Auto Configuration.
• Stateful Address Auto Configuration.
4. Click Apply to save your changes.
5. To verify the connection, click the Broadband Status (IPv6) option arrow in the upper right
of the screen to display the Connection Status pop-up screen. (The following figure shows a
dynamic IP address configuration.)
Figure 16.
The Connection Status screen should show a valid IP address and gateway, and you are
connected to the Internet. If the configuration was not successful, see
ISP Connection
Note: For more information about the Connection Status screen, see
the WAN Port Status

Manually Configure an IPv6 Internet Connection

To manually configure an IPv6 Internet connection, you need to receive static IP address
information from your ISP.

To manually configure the IPv6 broadband ISP settings:
1. Select Network Configuration > WAN Settings > Broadband ISP Settings (IPv6).
The Broadband ISP Settings (IPv6) screen displays:
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
on page 323.
on page 311.
Internet and Broadband Settings
34
Troubleshoot the
View