NETGEAR FVS318N Reference Manual page 158

ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Figure 84.
2. Complete the settings as explained in the following table:
Table 35. IPSec VPN Wizard settings for a gateway-to-gateway tunnel
Setting
About VPN Wizard
This VPN tunnel will connect
to the following peers
Connection Name and Remote IP Type
What is the new Connection
Name?
What is the pre-shared key?
End Point Information
What is the Remote WAN's IP
Address or Internet Name?
What is the Local WAN's IP
Address or Internet Name?
Virtual Private Networking Using IPv4 IPSec and L2TP Connections
Description
Select the Gateway radio button. The local WAN port's IP address or
Internet name displays in the End Point Information section of the screen.
Enter a descriptive name for the connection. This name is used to help you
to manage the VPN settings; the name is not supplied to the remote VPN
endpoint.
Enter a pre-shared key. The key needs to be entered both here and on the
remote VPN gateway. This key needs to have a minimum length of
8 characters and should not exceed 49 characters.
a
Enter the IP address or Internet name (FQDN) of the WAN interface on the
remote VPN tunnel endpoint.
When you select the Gateway radio button in the About VPN Wizard
section of the screen, the IP address of the wireless VPN firewall's active
WAN interface is automatically entered.
158