NETGEAR FVS318N Reference Manual page 180

IKE Policies Screen

To access the IKE Policies screen:
Select VPN > IPSec VPN. The IPSec VPN submenu tabs display with the IKE Policies
screen in view. (The following figure shows some examples.)
Figure 110.
Each policy contains the data that are explained in the following table. These fields are
explained in more detail in
Table 43. IKE Policies screen information
Item
Name
Mode
Local ID
Remote ID
Encr
Auth
DH
Virtual Private Networking Using IPv4 IPSec and L2TP Connections
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Table 44 on page 183.
Description
The name that identifies the IKE policy. When you use the VPN Wizard to set up a VPN
policy, an accompanying IKE policy is automatically created with the same name that you
select for the VPN policy.
Note: The name is not supplied to the remote VPN endpoint.
The exchange mode: Main or Aggressive.
The IKE/ISAKMP identifier of the wireless VPN firewall. The remote endpoint needs to
have this value as its remote ID.
The IKE/ISAKMP identifier of the remote endpoint, which needs to have this value as its
local ID.
The encryption algorithm that is used for the IKE security association (SA). This setting
needs to match the setting on the remote endpoint.
The authentication algorithm that is used for the IKE SA. This setting needs to match the
setting on the remote endpoint.
The Diffie-Hellman (DH) group that is used when keys are exchanged. This setting needs
to match the setting on the remote endpoint.
180