NETGEAR FVS318N Reference Manual page 295

ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
2. Enter the settings as explained in the following table:
Table 74. Firewall Logs & E-mail screen settings
Setting Description
Log Options
Log Identifier Enter the name of the log identifier. The identifier is appended to log messages to identify
the device that sent the log messages. The default identifier is FVS318N.
Routing Logs
In the Accepted Packets and Dropped Packets columns, select check boxes to specify which traffic is
logged:
• LAN to WAN
• LAN to DMZ
• DMZ to WAN
• WAN to LAN
• DMZ to LAN
• WAN to DMZ
System Logs Option
Select the check boxes to specify which system events are logged:
• Change of Time by NTP. Logs a message when the system time changes after a request from an NTP
server.
• Login Attempts. Logs a message when a login is attempted. Both successful and failed login attempts
are logged.
• Secure Login Attempts. Logs a message when a secure login is attempted. Both successful and failed
secure login attempts are logged.
• Reboots. Logs a message when the wireless VPN firewall has been rebooted through the web
management interface. (No message is logged when the factory default Reset button has been pressed.)
• All Unicast Traffic. All incoming unicast packets are logged.
• All Broadcast/Multicast Traffic. All incoming broadcast and multicast packets are logged.
• WAN Status. WAN link status-related events are logged.
• Resolved DNS Names. All resolved DNS names are logged.
• VPN. All VPN negotiation messages are logged.
• DHCP Server. All DHCP server events are logged.
Other Event Logs
Source MAC Select this check box to log packets from MAC addresses that match the source MAC
Filter address filter settings.
Session Limit Select this check box to log packets that are dropped because the session limit has been
exceeded.
Bandwidth Select this check box to log packets that are dropped because the bandwidth limit has been
Limit exceeded.
Monitor System Access and Performance
295