NETGEAR FVS318N Reference Manual page 168

ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Figure 95.
b. Specify the default lifetimes in seconds:
• Authentication (IKE), Default. The default lifetime value is 3600 seconds.
Change this setting to 28800 seconds to match the configuration of the wireless
VPN firewall.
• Encryption (IPSec), Default. The default lifetime value is 1200 seconds. Change
this setting to 3600 seconds to match the configuration of the wireless VPN
firewall.
8. Click Apply to use the new settings immediately, and click Save to keep the settings for
future use.
The VPN client configuration is now complete.
Instead of using the wizard on the VPN client, you can also manually configure the VPN
client, which is explained in the following section.
Manually Create a Secure Connection Using the NETGEAR VPN Client
Note: Perform these tasks from a PC that has the NETGEAR ProSafe
VPN Client installed.
To manually configure a VPN connection between the VPN client and the wireless VPN
firewall, create authentication settings (phase 1 settings), create an associated IPSec
configuration (phase 2 settings), and then specify the global parameters.
Virtual Private Networking Using IPv4 IPSec and L2TP Connections
168