NETGEAR FVS318N Reference Manual page 167

ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
c. Specify the settings that are explained in the following table.
Table 38. VPN client advanced authentication settings
Setting
Advanced features
Aggressive Mode
NAT-T
Local and Remote ID
Local ID
Remote ID
7. Configure the global parameters:
a. Click Global Parameters in the left column
Global Parameters pane displays in the
Virtual Private Networking Using IPv4 IPSec and L2TP Connections
Description
Select this check box to enable aggressive mode as the mode of negotiation
with the wireless VPN firewall.
Select Automatic from the drop-down list to enable the VPN client and
wireless VPN firewall to negotiate NAT-T.
As the type of ID, select DNS from the Local ID drop-down list because you
specified FQDN in the wireless VPN firewall configuration.
As the value of the ID, enter remote.com as the local ID for the VPN client.
Note: The remote ID on the wireless VPN firewall is the local ID on the VPN
client. It might be less confusing to configure an FQDN such as client.com as
the remote ID on the wireless VPN firewall and then enter client.com as the
local ID on the VPN client.
As the type of ID, select DNS from the Remote ID drop-down list because
you specified an FQDN in the wireless VPN firewall configuration.
As the value of the ID, enter local.com as the remote ID for the wireless
VPN firewall.
Note: The local ID on the wireless VPN firewall is the remote ID on the VPN
client. It might be less confusing to configure an FQDN such as router.com
as the local ID on the wireless VPN firewall and then enter router.com as the
remote ID on the VPN client.
Configuration Panel screen.
167
of the Configuration Panel screen. The