NETGEAR FVS318N Reference Manual page 202

ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Table 49. Add Mode Config Record screen settings (continued)
Setting
Integrity Algorithm
Local IP Address
Local Subnet Mask
4. Click Apply to save your settings. The new Mode Config record is added to the List of Mode
Config Records table.
Continue the Mode Config configuration procedure by configuring an IKE policy.
5. Select VPN > IPSec VPN. The IPSec VPN submenu tabs display with the IKE Policies
screen in view (see
6. Under the List of IKE Policies table, click the Add table button. The Add IKE Policy screen
displays.
Virtual Private Networking Using IPv4 IPSec and L2TP Connections
Description
From the drop-down list, select one of the following two algorithms to be used in the
VPN header for the authentication process:
• SHA-1. Hash algorithm that produces a 160-bit digest. This is the default setting.
• MD5. Hash algorithm that produces a 128-bit digest.
The local IP address to which remote VPN clients have access. If you do not
specify a local IP address, the wireless VPN firewall's default LAN IP address is
used (by default, 192.168.1.1).
The local subnet mask. Typically, this is 255.255.255.0.
Note: If you do not specify a local IP address, you do not need to specify a subnet
either.
Figure 110 on page 180).
202