NETGEAR FVS318N Reference Manual page 100

3. Specify the settings as explained in the following table:
Table 24. Add Access Point screen settings
Settings
AP Name
Profile Name
VLAN
Active Time
Start Time
Stop Time
WLAN Partition
4. Click Apply to save your settings. The new VAP is added to the List Of Available Access
Points table.

To enable or disable one or more VAPs:
1. On the Access Point screen (see
of each VAP that you want to enable or disable, or click the Select All table button to
select all VAPs.
2. Click one of the following table buttons:
• Enable. Enables the VAP or VAPs and allows wireless clients to make a connection.
• Disable. Disables the VAP or VAPs and prevents wireless clients from making a
connection.

To edit a VAP:
1. On the Access Point screen (see
Action column for the VAP that you want to modify. The Edit Access Point screen
displays. This screen is identical to the Add Access Point screen.
2. Modify the settings as explained in the previous table.
3. Click Apply to save your settings.
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Description
The name for the default VAP is ap1. You cannot change this name. For
additional VAPs, enter a unique name to make it easy to recognize the profile.
You can enter a value of up to 32 alphanumeric characters.
From the drop-down list, select the profile that should be allocated to the VAP.
From the drop-down list, select the VLAN to which the VAP should be allocated.
To enable the timer, select the Active Time check box. When the timer is
enabled, the VAP is turned off from the start time until the stop time. To disable
the timer, clear the check box.
Specify the start hour in the Hours field and the start minute in the Minutes field,
and then select AM or PM from the drop-down list.
Specify the stop hour in the Hours field and the stop minute in the Minutes field,
and then select AM or PM from the drop-down list.
To enable wireless client separation and prevent wireless clients that are
connected to this VAP from communicating with each other, select the WLAN
Partition check box. The disable wireless client separation, clear the check
box. By default, WLAN partition is disabled.
Figure 48
Figure 48
Wireless Configuration and Security
on page 98), select the check box to the left
on page 98), click the Edit button in the
100