Manually Configure An Ipv4 Internet Connection - NETGEAR FVS318N Reference Manual

Figure 10.
The Connection Status screen should show a valid IP address and gateway, and you are
connected to the Internet. If the configuration was not successful, skip ahead to
Configure an IPv4 Internet Connection
Connection on page 323.
Note: For more information about the Connection Status screen, see
the WAN Port Status
If the automatic WAN ISP configuration is successful, you can skip ahead to
IPv4 WAN Mode on page 31.

Manually Configure an IPv4 Internet Connection

Unless your ISP automatically assigns your configuration through a DHCP server, you need
to obtain configuration parameters from your ISP to manually establish an Internet
connection. The required parameters for various connection types are listed in
page 26.

To manually configure the IPv4 broadband ISP settings:
1. Select Network Configuration > WAN Settings > Broadband ISP Settings (IPv4).
The ISP Broadband Settings (IPv4) screen displays (see
2. Locate the IPS Login section on the screen:
Figure 11.
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
on page 311.
Internet and Broadband Settings
on page 27, or see Troubleshoot the ISP
Figure 9
27
Manually
View
Configure the
Table 2 on
on page 25).