Opos Origin; In Combination With Opos X Mode; In Combination With Opos Xy Mode - Summa S class 2 series User Manual

S CLASS™ 2 cutter

3.4.1 OPOS origin

The parameter OPOS origin is created to automate the start of the OPOS procedure. This
parameter has 4 settings. The usage of this parameter depends on the chosen OPOS mode.
If the OPOS is OPOS barcode or OPOS Sheet, then this parameter has no effect.
The useful combinations are visible in the below table.
Mark
XY-correction line
Current Position
Center of Media

3.4.1.1 In combination with OPOS X mode

The OPOS Origin is set to 'Mark'.
This is the default setting. Upon receiving an OPOS job from the computer, the cutter will
prompt the user to set the tool above the first mark and press Apply. The cutter will then
start searching for the OPOS mark around that position.
The OPOS Origin is set to 'Current position'.
Upon receiving an OPOS job from the computer, the cutter will immediately start looking
for the mark when it receives an OPOS job from the computer, without waiting for the user
to move the tool. Therefore, the user will have to set the tool above the first mark while
loading the material.
If the OPOS origin is set to either 'XY-correction line' or 'Center of media', then the cutter will
react as if the parameter was set to 'Indicate mark'

3.4.1.2 In combination with OPOS XY mode

The OPOS Origin is set to 'Mark'.
This is the default setting. Upon receiving an OPOS job from the computer, the cutter will
prompt the user to set the tool above the first mark and press Apply. The cutter will then
start searching for the OPOS mark around that position.
The OPOS origin is set to 'Indicate line'
Upon receiving an OPOS job from the computer, the cutter will prompt the user to set the
tool under the OPOS XY line and press Apply. The cutter will then start searching for the
OPOS XY line by slowly moving forward the media. Once it has found the OPOS XY line, it
will follow this line to the right until it finds the first mark and will then start searching for
the actual mark.
Contour Cutting
OPOS X
'Indicate Mark'
-
'Current Position'
-
User's Manual
OPOS XY
'Indicate Mark'
'Indicate Line'
'Current Position'
'Center of media'
3-12