Knife Pressure Test Pattern - Summa S class 2 series User Manual

S CLASS™ 2 cutter
 Setting the pressure and checking the knife depth:
(the media must be loaded in the cutter before the knife pressure can be tested).
WARNING: Each keystroke can initiate an internal test or movement of the
head or media. Keep fingers and other body parts away from the cutting area.
There are hazardous moving parts.
1. Power on the cutter and load the media.
Origin Pause
Configuration 1
Media size 50000 x 718 mm
Tool Tangential knife
Velocity 800 mm/s
Knife pressure 95 gr
Summa USB port 1
2. Press on pressure
1. Press
2. Press
Cancel
3. Press
Test
Once is pressed, the current knife pressure value will be set automatically to the
new value and the cutter will cut the knife pressure test pattern.
Peel out the rectangle and inspect the backing.
The knife depth is set correctly when the test pattern cuts completely through the vinyl.
The vinyl is removed and the blade tip visibly scratched the front side of the media backing.
The blade should never cut through the backing but only slightly scratch the silicon coating
and first few fibers of the backing material.
Setup
Settings
Old value: 85gr
New value: 95gr
Actions
Range: 0 ... 600gr
3. Press the arrow up or
down to change the value.
Test
to perform the internal knife pressure test.
Apply
to confirm the chosen knife pressure and exit the menu.
to leave the pressure unchanged.
FIG 1-33
1-33

KNIFE PRESSURE TEST PATTERN

Cancel
9▌
Apply
Numpad
Test
Summa USB port 1
4. Or fill in the new value
after pressing Numpad.
User's Manual
Apply
Summa USB port 1
1-33