Differences In Calibrating Opos Cam Vs Opos Sensor; Opos Calibration; Opos Media Calibration - Summa S class 2 series User Manual

S CLASS™ 2 cutter

3.5.2 Differences in calibrating OPOS CAM vs OPOS sensor

3.5.2.1 OPOS calibration

The OPOS calibration of a cutter with the OPOS CAM option is very similar to the OPOS
calibration of a cutter with an OPOS sensor.
1. Switch the cutter on and load black vinyl with white backing. Make sure Summa Cutter
Control is running on the computer that is connected to the cutter.
NOTE: Black vinyl with white backing MUST be used when calibrating OPOS.
Origin Pause
Configuration 1
Media size 50000 x 718 mm
Tool Tangential knife
Velocity 800 mm/s
Knife pressure 95 gr
Summa USB port 1 Summa USB port 1
2. Press Settings
Calibrate OPOS
Alignment mode OPOS X
OPOS sheet mode Off
OPOS panelling Off
OPOS origin
Mark
Settings | OPOS
5. Press Calibrate OPOS
OPOS will register the position of the little square and calibrate itself accordingly.

3.5.2.2 OPOS media calibration

This option is not available in the menu on the cutter. The camera has to be calibrated with
the program Cutter Control. The cutter tools manual describes how to do this.
Contour Cutting
Settings
Tool Tangential knife
Velocity
Knife pressure
Calibrate knife
Actions
FlexCut
General Advanced cutting
Settings
3. Press More
Home
The cutter will cut out two
squares, a little one inside a
More
big one. Afterwards it will
feed the media forwards.
Back
"Weed out Rectangle" will
appear on the display.
Home
General
800 mm/s
OPOS
More
95 gr
Communication
Length calibration
Back
...
Coil setup
... ...
Confidence test
Settings
4. Press OPOS.
Weed out rectangle
Settings | OPOS
6. Carefully
rectangle, making sure the
small square stays on its
place. Press Back.
User's Manual
Home
...
...
More
...
Back
Back
weed the
3-20