Summa S class 2 series User Manual page 34

S CLASS™ 2 cutter
 Loading a sheet.
Origin Pause
Configuration 1
Media size 50000 x 718 mm
Tool Tangential knife
Velocity 800 mm/s
Knife pressure 95 gr
Summa USB port 1 Summa USB port 1
1. Press on Media size
The cutter will immediately start to load the sheet. It measures the width and loads a certain
length of media, or until the end of the media is reached. The user will then be prompted to
accept the length or not.
Accept
3. Press
to accept the length or go to step 4.
The cutter will now complete the loading sequence, come online and will be ready to receive
data. The loading sequence conditions the edges of the vinyl for a given length.
Abort
4. Press
.
5. Press
or
The cutter will now complete the loading sequence. The cutter will come online and will be
ready. The length of the job is limited to the loaded length.
NOTE: If the rear media sensor detects the end of the media, the cutter will
complete the loading sequence without any input from the user.
Setup
Settings
Media alignment
Velocity 800 mm/s
Roll
Sheet
Extended
Actions
Load
2. Press on Sheet
until the required media-length appears. Then press
User's Manual
Home
Back
Apply
.
1-24