Powering-On The Cutter; Cutter Is Loaded And Ready; Cutter Is Ready - No Media Loaded - Summa S class 2 series User Manual

S CLASS™ 2 cutter

1.4 Powering-on the cutter

WARNING: Make sure the power switch is turned off before connecting the
power cord (the "0" side of the ON/OFF rocker switch should be pressed).
WARNING: Do not use the power cord if it is visibly damaged. Disconnect the
power cord by pulling the plug, not the cable.
WARNING: Keep fingers and other body parts away from the cutting area.
There are hazardous moving parts.
1. Plug the female end of the AC power cord into the receptacle, located in the power
entry module at the cutter's rear panel.
2. Plug the male end of the AC power cord into a properly grounded wall socket.
3. Power on the cutter by pressing the "I" side of the ON/OFF rocker switch, which is
located on the power entry module at the rear panel.
4. The touch screen will activate and the initialization process will begin. If media is
loaded, the cutter will check the size and load the media.
Origin
Configuration 1
Media size 50000 x 718 mm
Tool Tangential knife
Velocity
Knife pressure
FIG 1-13
1-13

CUTTER IS LOADED AND READY

Setup
Pause Settings
Actions
800 mm/s
95 gr
Summa USB port 1
Configuration 1
I n s e r t m e d i a a n d l o w e r t h e p i n c h r o l l e r s .
FIG 1-14
1-14

CUTTER IS READY - NO MEDIA LOADED

User's Manual
Settings
Action s
1-12