How To Set Tool Parameters; Setting The Tool Type - Summa S class 2 series User Manual

S CLASS™ 2 cutter

2.2 How to Set Tool Parameters

The S CLASS 2 cutters can work with a knife, pen or pouncer. With the T version you have
the choice between drag knife and tangential knife.
Once a tool has been changed, the tool parameters (menu settings) must be reset or
checked.
All the different tools have one parameter name in common: the pressure.
Each tool also has its specific parameters.
Tool parameters can be changed by either changing them in the current user, or simply by
changing the user (see section 2.1.5).
NOTE: The S CLASS 2 cutters will only perform according to specifications if a
genuine Summa knife, pen or pouncing tool is installed. Do not replace the
standard knife, pen or pouncing tool with products from other manufacturers.
WARNING: Each keystroke can initiate an internal test or movement of head or
media. Keep fingers and other body parts away from the cutting area. There are
hazardous moving parts.

2.2.1 Setting the tool type

1. Power on the cutter and load the media.
Origin Pause
Configuration 1
Media size 50000 x 718 mm
Tool Tangential knife
Velocity 800 mm/s
Knife pressure 95 gr
Summa USB port 1 Summa USB port 1
2. Press Tool
The cutter will prompt the user to change the tool.
NOTE: If no media is loaded, then access the tool menu by pressing
cutter will prompt the user after the media is loaded for a tool change.
Basic Operation
Settings
Pouncer
Ballpoint
Drag knife
Tangential Knife
Actions
3. Select tool
Cancel
Pouncer
Ballpoint
Drag knife
Tangential Knife
Apply
Summa USB port 1
4. Press Apply to select the
tool that is highlighted on
screen.
User's Manual
Cancel
Apply
Summa USB port 1
Settings
. The
2-6