Creating The Graphic - Summa S class 2 series User Manual

S CLASS™ 2 cutter

3.2.1 Creating the graphic

1. Create the graphic and contour cut line(s). For easier handling, place the contour line(s)
on a different layer.
NOTE: Some RIP software require that the contour lines are defined in special
color (spot color). Please refer to the user's manual that came with your software
or contact your software dealer for specifics.
NOTE: Do not place contour lines along the edges of graphics or the slightest
movement in the media may result in an unsatisfactory cut. Instead, practice one
of the following techniques.
1. Place contour lines just inside the graphics (recommended) (1).
2. Place contour lines outside the graphics (2).
3. Create thick borders around graphics and place contour lines inside these
borders (3).
(1) contour line
inside a graphic
recommended
Contour Cutting
(2) contour line
outside a graphic inside a thick border
(3) contour line Contour line on the
edge of a graphic
User's Manual
3-2