Summa S class 2 series User Manual page 73

S CLASS™ 2 cutter User's Manual
The OPOS origin is set to 'Current Position'
Upon receiving an OPOS job from the computer, the cutter will immediately start searching
for the OPOS XY line by slowly moving forward the media. Once it has found the OPOS XY
line, it will follow this line to the right until it finds the first mark and will then start searching
for the actual first mark. Therefore, the user will have to set the origin under the OPOS XY
line, immediately after the media has been loaded.
This setting was created for jobs that are aligned at the left side and differ a lot in size on the
roll. The origin/tool can then be set to the left of the media, under the OPOS XY line in order
to be able to find the origin mark, even if it is situated far from the right side of the media.
OPOS origin is set to 'Centre of media'
Upon receiving an OPOS job from the computer, the cutter first sets the OPOS sensor in the
middle of the media. Then it will start searching for the OPOS XY line by slowly moving
forward the media. Once it has found the XY line, it will follow the XY line to the right until it
finds the first mark and will then start searching for the actual mark.
This setting has been created for jobs on a roll where the width of each job is at least half
the width of the media (this is usually the case; otherwise there is lots of wasted media).
This method is slightly slower than the previous method.
Contour Cutting 3-13