Summa S class 2 series User Manual page 82

S CLASS™ 2 cutter
Old value: 10mm
New value: 10mm
Numpad
Range: 0.250 ... 250.000
mm
Settings | FlexCut
Old value: 80 gr
New value: 80 gr
Numpad
Range: 0 ... 600 gr
Settings | FlexCut
Old value: 1mm
New value: 1mm
Numpad
Range: 0.250 ... 250.000
mm
Settings | FlexCut
The cutter will cut out a test pattern.
4. Check if the result is satisfactory. If not, change one of the above 4 parameters.
Reducing the velocity can also improve the result. It is never recommended to use
cutting speeds larger than 400mm/s (16 ips) with cutting pressures above 200 gr.
NOTE: It is not always easy to find the correct balance between cutting deep
enough, making sure the pieces can be taken out easily, and not cutting too
deep, making sure the material keeps its strength while cutting. Sometimes this
balance doesn't exist, which means that this material can't be cut through with
satisfactory result.
NOTE: When cutting through, it is recommended that parallel lines are at least 1
cm away from each other. Otherwise, while cutting the second line, the first line
may come loose and cause trouble.
NOTE: FlexCut parameters are always metric, regardless the value of the panel
Units parameter.
NOTE: FlexCut can be set off or on for older types of software that cannot switch
FlexCut on or off. It is recommended to only use the accurate mode.
5. After that press
Contour Cutting
Cancel
Press the arrows or use
Test
Numpad to change the Full
pressure cut length and
Apply
press Apply to confirm.
Cancel
Press the arrows or use
Test
Numpad to change the Flex
pressure and press Apply to
Apply
confirm.
Cancel
Press the arrows or use
Test
Numpad to change the Flex
pressure cut length and
Apply
press Test to confirm.
Apply
to get in the FlexCut menu and then press
User's Manual
10mm is a recommended
starting value for the cutting
length at full pressure.
50% of the full pressure is a
recommended starting value
for the flex (bridge) pressure.
1mm is a recommended
starting value for the cutting
length at flex pressure.
Back
3-22