Opos Paneling - Summa S class 2 series User Manual

S CLASS™ 2 cutter

3.2.6 OPOS paneling

With this option, the job can be divided into panels in order to avoid moving the media
unnecessarily back and forth. When OPOS paneling is activated, all cut data will be cut in
panels. The size of the panel will be the distance between the OPOS marks in the X-axis.
OPOS Panels can be set to OFF or ON. When set to ON, the cutter will only load 2 marks in
the X-direction when loading OPOS and read the marks. The rest of the marks will be read
during unrolling the media, one panel at a time.
NOTE: Do not use software paneling when using OPOS paneling.
Activating OPOS paneling:
Origin Pause
Configuration 1
Media size 50000 x 718 mm
Tangential knife
Tool
Velocity 800 mm/s
Knife pressure 95 gr
Summa USB port 1 Summa USB port 1
1. Press Settings
Calibrate OPOS
Calibrate media (OPOS)
Alignment mode OPOS X
OPOS sheet mode Off
OPOS panelling Off
OPOS origin
Mark
Settings | OPOS
4. Press OPOS paneling.
Contour Cutting
Settings
Tool Tangential knife
Velocity
Knife pressure
Calibrate knife
Actions
FlexCut
General Advanced cutting
Settings
2. Press More
Home
Off
On
More
Back
Settings | OPOS
.
5. Press and then Apply.
Home
General
800 mm/s
OPOS
More
95 gr
Communication
Length calibration
Back
...
Coil setup
... ...
Confidence test
Settings
3. Press OPOS.
Cancel
Apply
User's Manual
Home
...
...
More
...
Back
3-7