Feeding Roll Media Without Using Media Flanges; Media Position - Summa S class 2 series User Manual

S CLASS™ 2 cutter
1-20
5. Start feeding the media from the rear of the machine. Pass the media underneath the
pinch rollers towards the front of the machine.
6. Position the left media edge on the left-most drive sleeve and check whether the right
media edge is positioned over the long drive sleeve. Then position the left and right
pinch rollers.
The pinch rollers should be positioned over the drive sleeves about 3 to 15 mm (0.1" to
0.6") away from the media's outer edges (1). Then pull the media while holding the
flange at the back so the media is tight. Make sure the front media sensor is covered (2).
In circumstances where the above procedure does not work, because the media is too
narrow to reach the long drive sleeve, try positioning the left media edge over the
second left drive sleeve and position the right media edge somewhere over the long
drive sleeve. Continue moving the left pinch roller toward the long drive sleeve until
both pinch rollers click in their designated position and directly over the edges of the
vinyl.
In all cases, both edges of the media must cover a drive sleeve. If this is not the case,
reposition the roll of material to cover the drive sleeve.
7. Make sure that the media follows a straight path from the roll of material. To accomplish
this, slide the media roll and flange guides from the left to the right along the media
support rollers.
Setup
FIG 1-20

FEEDING ROLL MEDIA WITHOUT USING MEDIA FLANGES

FIG 1-21
1-21

MEDIA POSITION

User's Manual
1-21