Cutting The Same Graphic On Multiple Media Sheets; Positioning The Media For Multiple Sheets - Summa S class 2 series User Manual

S CLASS™ 2 cutter

3.4.3 Cutting the same graphic on multiple media sheets

If the same graphic design needs to be printed on multiple sheets, this feature can be used.
NOTE: The sheets should have more or less the same size, and the graphics on
them should be oriented and positioned the same way.
NOTE: OPOS sheet mode ignores the parameter OPOS origin, so the tool will
always have to bet set manually for the first job.
First, load the media and check whether the parameters of the OPOS marks are set correctly.
Cutting the same graphic on multiple media sheets:
Origin Pause
Configuration 1
Media size 50000 x 718 mm
Tool Tangential knife
Velocity 800 mm/s
Knife pressure 95 gr
Summa USB port 1
1. Press Settings.
4. Do the job on the first sheet.
The cutter will stop after the first contour has been cut and will come online again.
5. Raise the pinch rollers and remove the sheet manually.
6. Insert the next sheet into the cutter. Lower the pinch rollers.
NOTE: The second and any following sheet must be loaded in the cutter at the
same position and orientation as those from the first sheet. When in OPOS sheet
mode, the cutter stores the distance between the edges of the sheet and the first
OPOS mark.
NOTE: Use easy orientation points to be able to quickly position the sheet. In the
figure below, a rim of the base plate and the side of the pinch roller assembly are
used to align the sheets.
Contour Cutting
Settings OPOS Barcode
Cut tests Open file
Load Cut off
Actions
2. Press OPOS sheet mode.
FIG 3-1
3-1

POSITIONING THE MEDIA FOR MULTIPLE SHEETS

OPOS sheet
Home
Off
mode
On
Replot
Cut sheet Reset
Summa USB port 1
Settings | OPOS
3. Press Apply.
User's Manual
Cancel
Apply
3-15