Mounting The Cutter On The Stand; Completely Assembled Stand For The S Class 2 Cutter; Position Of The Screws - Summa S class 2 series User Manual

S CLASS™ 2 cutter
8. Make sure the linen basket is guided under the horizontal panel. Take the last large c-
shaped tube and feed it through the rear hem in the linen basket. Then put the tube on
the two rear tubes that stick out of the feet. Make sure the holes are orientated with the
right side upwards, so that the tube clicks securely on the tubes. The finished stand
should look like the stand in the picture below (Figure 1-8).
1-8

COMPLETELY ASSEMBLED STAND FOR THE S CLASS 2 CUTTER

9. The right leg contains a hole in the foot and a cutout in the leg in order to guide the
power cable and data cable. If you plan to use these cable guides, then put the cables in
place before mounting the cutter on the stand.

1.1.3 Mounting the cutter on the stand

1. Carefully take the cutter out of the box and lay it on its back (first spread out the
cardboard of the stand box, and then rest the cutter on that cardboard). Insert the left
and right two screws and turn them 3 turns in. Do not put a screw in at the front.
2. Put the cutter on its stand. Put a lockwasher on the two remaining screws and put them
in the two remaining holes. Then secure all six screws.
3. Loosen the cutting head. Raise the pinch rollers to remove the protection strip from
underneath the pinch roller assemblies.
Setup
FIG 1-8
FIG 1-9
1-9

POSITION OF THE SCREWS

User's Manual
1-4