Replacement Of The Separation Knife Blade; Razor Blade For Automatic Separation Of Media - Summa S class 2 series User Manual

S CLASS™ 2 cutter

1.7.3 Replacement of the separation knife blade

The tool carriage also holds the separation knife. With this knife (razor blade), the job can be
cut off automatically, after it is finished.
NOTE: This separation knife should only be used with standard vinyl (max
0.25mm thick).
1. Remove the razor blade holder by turning on the knurled screw at the bottom of the
tool carriage.
2. The razor blade is kept in its place by a small magnet. Turn it around or replace it when
it is worn down; figure 1-b.
1-34
NOTE: The assembly is tilted under an angle of +/- 30° when it is put back on
the machine. Mind the position of the assembly before replacing the razor
blade.
Setup
1-34

RAZOR BLADE FOR AUTOMATIC SEPARATION OF MEDIA

User's Manual
1-36